DETERMINATION OF THE CORRUGATION PARAMETERS AT COMBINED OPERATION OF REDUCTION AND FORMING OF CORRUGATION OF TUBULAR BLANKS

Володимир Володимирович Борисевич, Мохамед Абубакер Абухабел

Abstract


The results of numerical modelling of corrugation forming at combination of reduction and corrugation formation of the tubular blanks are given. There were sequentially modelled initial buckling with symmetrical bulging and further plastic flow.  The results of modelling were compared for the different parameters of the technological process and for the different correlation of the initial blank dimensions. It is shown, that applied model describes corrugation formation adequately. Application of the model proposed is recommended for calculation of the parameters of the corrugation formation process with axial displacement of the material to the zone of deformation.


Keywords


corrugation; corrugation formation; buckling; plastic flow

References


Mescherin, V. T. Listovaya shtampovka [Sheet-metal working]. Moscow, Mashinostroenie Publ., 1975, pp. 75, 77.

Vol’mir, A. S. Ustoychivost’ uprugih system [Stability of the elastic systems]. Moscow, Science Publ., 1967. 984 p.

Nepershin, R. I. Plasticheskaya poterya ustoychivosti pri osevom szhatii truby [Plastic loosing of stability at axial compression of the tube]. Vestnik Samarskogo gosudarstvennogo ajerokosmicheskogo universiteta – Bulletin of the Samara State Aerospace University, 2011, no. 3(27), pp. 329-336.

Dongjie, Jiang., Nathan, J. Bechle., Chad, M. Landis., Stelios, Kyriakides. Buckling and recovery of NiTi tubes under axial compression. International Journal of Solids and Structures, 2016, vol. 80, pp. 52-63.

Lanhui, Guo., Yong, Liu., Hui, Jiao., Shilong, An. Behavior of Thin-walled Circular Hollow Section Stub Columns Under Axial Compression. Interna-tional Journal of Steel Structures, 2016, vol. 16(3), pp. 777-787.




DOI: https://doi.org/10.32620/aktt.2017.4.06