ПОЛУЧЕНИЕ МАТЕРИАЛА ДЛЯ ИЗГОТОВЛЕНИЯ КОМПОЗИТНЫХ КОНСТРУКЦИЙ МЕТОДОМ 3D-ПЕЧАТИ

Р. В. Лабза, В. В. Кнель

Abstract


In this article, we have considered the relevance of additive technologies for the manufacture of composite structures. We analyzed modern methods and difficulties in the manufacture of thermoplastic reinforced material. We designed and presented a mangling machine. The reinforcing material go through a roller system, and then falls between two hot rollers, where a rollers press molten thermoplastic into reinforcing material. Finally, we manufactured a mangling machine, tested it and showed the results.


Keywords


manufacturing of composite structures; additive technologies; mangling machine

References


Beyer, S.: Additive Manufacturing applied to liquid propulsion & equipment parts for next generation launcher – hurdle sand challenges along the value chain, SPC2016-3125070, Space Propulsion Conference 2016, 02.-06.06.2016, Rome, Italy.

Markforged Chopped Carbon 3D-Printer [Электронный ресурс]. – Режим доступа: https://www.engineering.com. – 17.09.2016 г.

Перспективы развития производства авиационных деталей из композиционных материалов / А.В. Калгин, Ю.Е. Калинин, А.М. Кудрин, А.В. Малюченков, Ю.В. Панин, А.В. Ситников // Вестник Воронежского государственного технического университета. – 2011. – № 112. – С. 146-153.

ОАО «Авангард». Опыт производства крупногабаритных изделий из композиционных материалов для ракетно-космической отрасли [Электронный ресурс]. – Режим доступа: http://www. avangard-plastik.ru. – 27.05.2011 г.

Основы технологии переработки пластмасс / С.В. Власов, Л.Б. Кандырин, В.Н. Кулезнев и др. – М.: Химия, 2004. – С. 336–349.

Современные технологии получения и переработки полимерных композиционных материалов / В.Е. Галыгин, Г.С. Баронин, В.П. Таров, Д.О. Завражин. – Тамбов: Изд-во ФГБОУ ВПО «ТГТУ», – 2012. – С. 54–100.


Refbacks

  • There are currently no refbacks.