ПРОГНОЗИРОВАНИЕ ПЛОТНОСТИ МНОГОМЕРНЫХ УГЛЕРОДНЫХ ПРЕФОРМ

А. В. Чесноков, М. Д. Нестеренко

Abstract


Research results are devoted to the prediction of multidimensional carbon preforms density. The main types of preforms are allocated and for them were determined the parameters of repeated elements. The possibility of technological reduction of the diameter of the produced rods is substantiated. A technique for predicting the density of preforms and determining the density of the resulting preforms by the parameters of the guiding plates for assembly are proposed and obtained spacing of the horizontal layers. It is shown that the applied preforms density is 0.6 g/cm3 can be doubled by using profile rods of boundary density.


Keywords


carbon-carbon composite material; multidimensional carbon preforms; profile rods

References


Fitzer E., Manocha L. Carbon Reinforcements and Carbon-Carbon Composites // Springer-Verlag Berlin Heidelberg New York, 1998. - 342 p.

Тишина У.А., Теплофизические характеристики композиционных материалов типа углерод-углерод / У.А. Тишина, Г.И. Курневич, Н.П. Радимов // Прикладная химия. – 1990. – №7. – С. 1544-1550.

Разработка и исследование трехмерно-армированных углепластиков на основе стержневых структур наполнителя : автореф. дис. ... канд. техн. наук : 05.16.06 / Гареев Артур Радикович. – Москва, 2015. - 22 с.

Tamayol, A., & Bahrami, M. (2009). Analytical determination of viscous permeability of fibrous porous media. International Journal of Heat and Mass Transfer, 52(9-10), 2407-2414.

Ряшенцев М.С. Определение кажущейся и истинной плотностей углерод-углеродных композиционных материалов и конструкционных графитов // М.С. Ряшенцев, С.А. Колесников. – Заводская лаборатория. Диагностика материалов. – 2016. – Т.82, №7. – С. 43-44


Refbacks

  • There are currently no refbacks.