Method of creation of power sources for home appliances under constraints of limited resources

Artem Perepelitsyn, Artem Tetskyi

Abstract


The subject of study in this article is the voltage ranges, methods, and tools for prototyping independent sources of power supply and artificial lighting for home appliances with reuse of only widespread components. The goal is to improve the efficiency of the creation and use of independent power supply sources for home appliances. Task: to analyze the history of the development of voltage standards for households; analyze existing autonomous power sources and types of batteries; analyze different loads; find rational voltage ranges based on fundamental values; analyze charge control and balancing circuits for lithium-based batteries; propose the technique of prototyping independent sources of power supply based on reused lithium-ion (Li-ion) accumulators; provide an example of the practical application of the results of research. According to the tasks, the following results were obtained. The evolution of voltage standards of electrical supply networks is analyzed. Types of autonomous power supplies, including pure sine versions, are discussed. The analysis of batteries for autonomous power sources of different chemical compositions is performed. It is proposed to use the water analogy of current and area as an analogy of battery capacity for visual representation of electrical processes. Models of constant current consumption and constant power consumption are considered. It is proposed to reduce the internal resistance of the battery assembly by parallel connection of the reused lithium-ion accumulators. Correspondence of voltage ranges of sequential connection of lithium-ion cells to ensure compatibility with existing devices is investigated. Rational parameters of voltage ranges to ensure compatibility of lithium-ion and acid accumulators with the ability to charge directly from solar panels without a charge controller are found. Charge controllers, battery management systems (BMS), and battery balancing circuits are analyzed. A set of steps for reuse of lithium-ion accumulators for the creation of autonomous power sources is proposed. Conclusions. The main contribution of this research is the proposed method of creation of power supply and interior lighting based on the reuse of accumulators without additional components. The discovered and proposed magic numbers of 3, 5, 7, 9, 11 and 13 for series connection of lithium-ion cells allows to obtain the equivalent of standard voltage ranges of 12 V, 19 V, 27 V, 36 V, 42 V and 48 V. The proposed technique of adjusting the voltage of the passive balancer allows adding 4.5 % to the capacity of the battery assembly. The described solutions allow to build the completely scalable autonomous low-voltage electrical supply network with the ability to charge directly from solar panels without expensive charge controllers.

Keywords


voltage ranges; accumulator; charge controller; solar panels; power supply; passive balancing; Li-ion; BMS; secondary good market; reuse of electronics

Full Text:

PDF

References


Ferrara, C., Ruffo, R., Quartarone, E. & Mustarelli, P. Circular Economy and the Fate of Lithium Batteries: Second Life and Recycling. Advanced Energy & Sustainability Research, 2021, vol. 2, iss. 10, no. 2100047, pp. 1-13. DOI: 10.1002/aesr.202100047.

Cattaneo, P., Callegari, D., Merli, D., Tealdi, C., Vadivel, D., Milanese, C., Kapelyushko, V., D'aprile, F. & Quartarone, E. Sorting, characterisation, environmentally friendly recycling and re-use of components from End-of-Life 18650 Li ion batteries. ChemRxiv, Cambridge: Cambridge Open Engage, 2023, preprint. DOI: 10.26434/chemrxiv-2023-x37mm.

Nováková, K., Pražanová, A., Stroe, D.-I. & Knap, V. Second-Life of Lithium-Ion Batteries from Electric Vehicles: Concept, Aging, Testing, and Applications. Energies, 2023, vol. 16, iss. 5, pp. 2345-2364. DOI: 10.3390/en16052345.

Harper, G., Sommerville, R., Kendrick, E., Driscoll, L., Slater, P., Stolkin, R., Walton, A., Christensen, P., Heidrich, O., Lambert, S., Abbott, A., Ryder, K., Gaines, L. & Anderson, P. Recycling lithium-ion batteries from electric vehicles. Nature, 2019, vol. 575, pp. 75-86. DOI: 10.1038/s41586-019-1682-5.

Neidhöfer, G. 50-Hz Frequency [History]. IEEE Power and Energy Magazine, 2011, vol. 9, iss. 4, pp. 66-81. DOI: 10.1109/MPE.2011.941165.

Kykta, M. The Incandescent Light Bulb and the Mystery of the Centennial Bulb. Information Display, 2021. 5 p. DOI: 10.1002/msid.0050001.

Goodenough, J. B. & Park, K.-S. The Li-Ion Rechargeable Battery: A Perspective. Journal of the American Chemical Society, 2013, vol. 135, iss. 4, pp. 1167-1176. DOI: 10.1021/ja3091438.

Estaller, J., Kersten, A., Kuder, M., Thiringer, T., Eckerle, R. & Weyh, T. Overview of Battery Impedance Modeling Including Detailed State-of-the-Art Cylindrical 18650 Lithium-Ion Battery Cell Comparisons. Energies, 2022, vol. 15, iss. 10, pp. 3822-2843. DOI: 10.3390/en15103822.

Byk, M. V., Frolenkova, S. V., Buket, O. I. & Vasyliev, H. S. Tekhnichna elektrokhimiia 2: Khimichni dzherela strumu [Technical electrochemistry 2: Chemical current sources]. Kyiv, KPI named after Igor Sikorsky, 2018. 321 p. Available at: https://ela.kpi.ua/bitstream/123456789/23888/3/Tehn_el_chem_part2_Power_sources.pdf (accessed June 1, 2022).

ICR18650-26F Cell Datasheet PDF. Available at: https://datasheetspdf.com/datasheet/ICR18650-26F.html (accessed June 1, 2022).

INR18650-25R Cell Datasheet PDF. Available at: https://datasheetspdf.com/datasheet/INR18650-25R .html (accessed June 1, 2022).

Starostin, I., Khalyutin, S., Davidov, A., Lyovin, A. & Trubachev, A. The Development of a Mathematical Model of Lithium-Ion Battery Discharge Characteristics. 2019 International Conference on Electro¬technical Complexes and Systems (ICOECS), 2019, pp. 1-4. DOI: 10.1109/icoecs46375.2019.8949976.

Said, A. O., Lee, C., Stoliarov, S. I. & Marshall, A. W. Comprehensive analysis of dynamics and hazards associated with cascading failure in 18650 lithium ion cell arrays. Applied Energy, 2019, vol. 248, pp. 415-428. DOI: 10.1016/j.apenergy.2019.04.141.

Said, A. O., Lee, C. & Stoliarov, S. I. Experimental investigation of cascading failure in 18650 lithium ion cell arrays: Impact of cathode chemistry. Journal of Power Sources, 2020, vol. 446, pp. 1-14. DOI: 10.1016/j.jpowsour.2019.227347.

Fursov, I., Yamkovyi, K. & Shmatko, O. Smart Grid and wind generators: an overview of cyber threats and vulnerabilities of power supply networks. Radioelectronic and Computer Systems, 2022, no. 4, pp. 50-63. DOI: 10.32620/reks.2022.4.04.

Kukurudziak, M. Silicon four element p-i-n photodiode with improved characteristics. Radioelectronic and Computer Systems, 2023, no. 1, pp. 92-100. DOI: 10.32620/reks.2023.1.07.

Sasaki, T., Ukyo, Y. & Novák, P. Memory effect in a lithium-ion battery. Nat Mater, 2013, vol. 12, iss. 6, pp. 569-575. DOI: 10.1038/nmat3623.

Kurt, Y. F. & Özer, T. 13S Battery Pack and Battery Management System Design and Implementation for Electric Bicycles. International Journal of Automotive Science and Technology, 2023, vol. 7, iss. 2, pp. 87-94. DOI: 10.30939/ijastech..1246624.

Raju, K. N., Naga Pavan, G., Subbarao, S. & Ahammad, S. H. Design of A 48V 13S Battery Management System For Enhanced Electric Vehicle Performance, IEEE 2nd Mysore Sub Section International Conference (MysuruCon), 2022, pp. 1-5. DOI: 10.1109/MysuruCon55714.2022.9972732.

Gozdur, R., Guzowski, B., Dimitrova, Z., Noury, A., Mitukiewicz, G. & Batory, D. An energy balance evaluation in lithium-ion battery module under high temperature operation. Energy Conversion and Management, 2021, vol. 227, no. 113565, pp. 1-12. DOI: 10.1016/j.enconman.2020.113565.

Haselhoff, E. Ultralow-Power Supply Voltage Supervisor Family TPS383x. Available at: https://ti.com/lit/an/slva091/slva091.pdf (accessed June 1, 2022).

Guo, J., Li, Y., Pedersen, K. & Stroe, D.-I. Lithium-Ion Battery Operation, Degradation, and Aging Mechanism in Electric Vehicles: An Overview. Energies, 2021, vol. 14, iss. 17, article no. 5220, pp. 1-22. DOI: 10.3390/en14175220.

Balagopal, B., Huang, C. S. & Chow, M.-Y. Sensitivity Analysis of Lithium Ion Battery Parameters to Degradation of Anode Lithium Ion Concentration. 45th Annual Conference of the IEEE Industrial Electronics Society (IECON 2019), 2019, pp. 4543-4548. DOI: 10.1109/iecon.2019.8926969.

Shi, Y., Yang, Y., Wen, J., Cui, F. & Wang, J. Remaining useful life Prediction for lithium-ion battery based on CEEMDAN and SVR. 2020 IEEE 18th International Conference on Industrial Informatics (INDIN), 2020, pp. 888-893. DOI: 10.1109/INDIN45582.2020.9442125.

Madani, S. S. & Ziebert, C. A Model-Based Approach for Temperature Estimation of a Lithium-ion Battery Pack. 2022 Asia Power and Electrical Technology Conference (APET), 2022, pp. 357-360. DOI: 10.1109/APET56294.2022.10072755.

Song, Y., Liu, D. & Peng, Y. Series-connected lithium-ion battery pack health modeling with cell inconsistency evaluation, 2019, 2019 IEEE International Instrumentation and Measurement Technology Conference (I2MTC), pp. 1-6. DOI: 10.1109/i2mtc.2019.8827097.

TP4056 1A Standalone Linear Li-lon Battery Charger with Thermal Regulation in SOP-8. Available at: https://pdf1.alldatasheet.com/datasheet-pdf/view/1487471/ETC2/TP4056.html (accessed June 1, 2022).

Huseynov, I. T. The characteristic analysis of continuous light diodes. Modern Physics Letters B, 2021, vol. 35, iss. 15, article no. 2150247, pp. 1-9. DOI: 10.1142/S021798492150247X.




DOI: https://doi.org/10.32620/reks.2023.2.07

Refbacks

  • There are currently no refbacks.