ANALYSIS OF THE EFFECT OF THE CONICAL ANGLE OF A COUNTERSUNK HOLE ON THE DISTRIBUTION OF RADIAL INTERFERENCE IN RIVETING

А. Г. Гребеников, А. М. Гуменный, С. П. Светличный

Abstract


The results of the analysis of the effect of the conical angle of a countersunk hole on the distribution of radial interference along the stack thickness in riveting are given. It has been determined by calculation that interference in riveting is distributed nonuniformly along the stack thickness. The increase in the conic angle of the hole for the snap head leads to a decrease in the amount of interference in this zone. To ensure the tightness of the joint, the conic angle of the hole seat in the top plate should be not more than 5 degrees.


Keywords


rivet; radial interference; finite element method; stress-strain state; plasticity

References


Гребеников, А.Г. Анализ влияния геометрических параметров гнезда под установку прогрессивной потайной заклепки АНУ0348 на характеристики локального НДС в пластине с зенкованным отверстием [Текст] / А.Г. Гребеников, Д.Ю. Дмитренко, Д.В. Хмелик // Открытые информационные и компьютерные интегрированные технологии: сб. науч. тр. Нац. аэрокосм. ун-та им. Н.Е. Жуковского «ХАИ». – Вып. 49. – Х., 2011. – С. 248 - 262.

Авиационные материалы: в 8 т. [Текст] / под общ. ред. д-ра техн. Наук Р.Е. Шалина. – М.: ОНТИ, 1982. – Т.4: Алюминиевые и бериллиевые сплавы. – 627 с.

ANSYS Element Guide. Chapter 3. Element References. Section 3.1. Element Library.001087. 4th Edition. SAS IP©.

ANSYS Contact Technology Guide. Chapter 3. Surface-to-Surface Contact. 001087. 4th Edition. SAS IP©.

Эксплуатация, обслуживание, ремонт, надежность [Текст] / Авиационный технический справочник; под общ. ред. В.Г. Александрова. – М.: Транспорт, 1969. – 412 с.

ANSYS Structural Analysis Guide. Chapter 8. Nonlinear Structural Analysis.Section 8.4.1.1.1 Plastic Material Models. 001087. 4th Edition. SAS IP©.


Refbacks

  • There are currently no refbacks.